By the time a driver reports a cab that sinks overnight, the tilt hose has usually been weeping for weeks. There is normally a dark patch on the cover, a damp ferrule, or a pump that has begun to labour under load. Left until it fails, the cab can drop without warning during a service check, and the leak leaves oil where it should not be.
Volvo Cabin Tilt Hose 85110481 is a reinforced rubber hose with steel end fittings crimped at both ends, and a cover that resists oil, ozone and road spray. It runs from the tilt pump up the rear of the cab, past the mounting, and onto the ram, held by clips that keep it off hot or sharp surfaces along the way.
In the workshop the cab is propped, the circuit is bled down and the old hose is unclipped from top to bottom. The new 85110481 goes in the same way, unions finger-tight first, then torqued to the maker's figure, with the hose checked for twist before the clips are closed. The system is bled, the cab is cycled, and the joints watched for a full cycle.
Orders ship as complete assemblies, each one capped, bagged and boxed with 85110481 on the label, and every carton is marked so that stock can be identified without opening it. Buyers should match the number to the chassis plate and confirm the hose length and fitting style, since a visually similar part can be wrong for a given cab.

Hot Tags: volvo cabin tilt hose 85110481, China volvo cabin tilt hose 85110481 manufacturers, suppliers, factory


