Begin by raising the cab and letting the system cool completely, then unbolt the clamp at the manifold and support the rear section before cutting anything. Remove the mounting rubbers, lower the old pipe and clean the flange faces. Offer up the Kamaz Exhaust Pipe 5320-1203012, check that the bend clears the frame, and only then tighten the joints from front to rear.
The pipe carries hot gas away from the engine and keeps the exhaust path at its intended length, so back pressure stays within the range the engine was set up for. A restricted or leaking section disturbs that balance, raising exhaust temperature and misleading the sensors that trim fuelling. On a working truck this shows as poor economy, black smoke under load and fumes in the cab.
Geometry follows the original route, with the main run kept straight between bends and each turn held wide enough to avoid a sharp restriction. Wall thickness is consistent along the length, including the curved sections where thinning would weaken the pipe. A fixed flange with a machined face closes the front end, and the rear end is sized for a sliding clamp joint.
A dependable replacement is formed from proper metal tube, welded on a jig so the bends land in the right place, and finished with a flat flange face that seals first time. A cheap look-alike often uses thinner wall, rough seams and a flange that is not true, which leaks or cracks within a season. Ask how the pipe is jigged and finished, and confirm 5320-1203012 against the old unit before buying.

Hot Tags: kamaz exhaust pipe 5320-1203012, China kamaz exhaust pipe 5320-1203012 manufacturers, suppliers, factory, 2x12 equivalent, 6204900365, Exhaust Flexible Pipe 3x6, Exhaust Pipe 1428892, Exhaust Pipe 81152100109, Universal Exhaust Flexible Pipe 2x12


