One Way Non Return Check Valve Aluminum 6-12mm

One Way Non Return Check Valve Aluminum 6-12mm
Details:
The number stamped on the hex of a failed valve is the first thing to read. Clean it, compare it with the parts listing for the vehicle, and confirm the tube sizes at both ends before ordering. On this valve the marking resolves to 6-12mm, which tells the store which bore range the body was made for. A photograph of the old unit saves a second trip.
Send Inquiry
Description
Send Inquiry
 

The number stamped on the hex of a failed valve is the first thing to read. Clean it, compare it with the parts listing for the vehicle, and confirm the tube sizes at both ends before ordering. On this valve the marking resolves to 6-12mm, which tells the store which bore range the body was made for. A photograph of the old unit saves a second trip.

Check valves fail in three familiar ways. Grit from a drying reservoir lodges on the seat and the valve never quite closes, so pressure creeps back down the line. The spring softens with heat cycles and the disc begins to flutter. Less often, the seal swells after contact with an incompatible oil and the valve sticks open. Any of the three shows as a slow pressure loss at the gauge.

The One Way Non Return Check Valve Aluminum 6-12mm uses a light aluminium body with a spring-loaded disc and a soft seat, and both ports are push-in style with collet and O-ring. The disc lifts only in the intended direction; reverse flow presses it back onto the seat. Ends seal on the tube's outside diameter, so no clamp is needed.

Fit the valve with the arrow pointing along the intended flow, because a reversed unit blocks the circuit and mimics a failed compressor. Push both tubes fully home, recharge, and watch the gauge for creep over several minutes. Before refitting, check the old seat for scoring and the reservoir for moisture; a dry 6-12mm valve in a wet system will fail again.

304One Way Non Return Check Valve Aluminum 6-12mm
 

Hot Tags: one way non return check valve aluminum 6-12mm, China one way non return check valve aluminum 6-12mm manufacturers, suppliers, factory, 4mm Air Hose Fitting replacement, 6 6mm, Explosion Proof Air Hose Fitting Reducing 6 8mm, M22x1 5 6 M22x1 5 8 Air Hose Fitting, Truck Air Hose Quick Connector replacement

Send Inquiry
Send Inquiry