A rattle under the cab that sharpens on cold mornings is often the first sign a driver notices, followed by a drone that drowns out conversation and a faint smell of exhaust in the wheel arch. By the time the truck reaches the workshop the leak has usually spread along a weld and the mounting points have begun to sag.
The Scania Exhaust Pipe 1505749 is formed in steel tube with welded flanges and a heat-resistant coating on the outer skin. Its route mirrors the factory line, dropping from the manifold, curving past the gearbox and rising towards the silencer inlet, so the gas path stays short in daily use and the pipe clears the frame, the air lines and the wiring loom.
Fitting is straightforward for anyone who has done this job before. Raise the cab, support the pipe, undo the clamps at both ends and free the hanger rubbers. Clean the mating faces, slide the new pipe into position, and tighten from the centre outwards so the joints settle evenly. A short run at idle confirms that the seal is sound.
Stock is held in sealed cartons with the 1505749 label facing outward, and each pipe is capped at both ends so grit and damp cannot enter the bore. Orders ship on a schedule agreed at the time of purchase, with quantities confirmed in writing. Before ordering, check the engine build and the number stamped on the old pipe, since close variants exist that look alike.

Hot Tags: scania exhaust pipe 1505749, China scania exhaust pipe 1505749 manufacturers, suppliers, factory, 1803510 Scania, 2 5x10, 2x12 equivalent, 3x12, 81152100109 Exhaust Pipe for sale, Universal Exhaust Flexible Pipe 2x12


