Oil leaving the turbocharger cannot simply drain anywhere; it must fall steadily back to the sump without meeting exhaust heat or a pressurised sump. The Hino Truck Turbo Oil Return Pipe S241061190 carries that flow from the bearing housing to the block at a consistent angle, so the drain stays open at idle and under load and the shaft seals never have to hold back oil.
Three places account for most failures. The first is the welded collar where the tube meets the upper flange, a joint that sees the full heat of the turbine housing. The second is the lower flange face, which distorts when bolt load is uneven. The third is the inside of the first bend, where oil residue bakes hard, narrows the bore and starts a fatigue crack.
Each unit is formed from steel tube rather than pressed sheet, with mandrel bends that keep the bore round through every turn. Welds sit evenly around both flanges, and the mating faces are machined flat so a gasket can seal without sealant. The outside is finished to resist underbody spray, and the bore is left clean of scale so oil carries no debris downward.
Fitment is straightforward once the old pipe is off: clean both mating faces, use a fresh gasket, and bring the bolts down evenly rather than in one pass. Ordering is by the reference S241061190 stamped on the original flange, quoted with the vehicle model and engine variant. If that stamping is unreadable, send photographs of both flanges and of the routing before committing.

Hot Tags: hino truck turbo oil return pipe s241061190, China hino truck turbo oil return pipe s241061190 manufacturers, suppliers, factory, 1225A018, 5135786AB genuine part, 994898565, Fiat Turbo Oil Return Pipe 0073500435 replacement, FORD Focus Escape Turbo Oil Pipe DS7G 6K677 GC, Ford Turbo Oil Pipe AG9G6K677BC replacement part


