Drainage
Water dripping from your car's exhaust pipe is a good sign. It proves that your car's engine is fully burning, and the car's exhaust pipe will drip water. In fact, this is a very normal phenomenon and has nothing to do with the exhaust pipe.
The reason why the exhaust pipe drips water is because after the car gasoline is completely burned, it generates carbon dioxide and water. Water turns into water vapor at high temperatures. Water vapor is colorless and transparent at high temperatures. However, when the water is lower than 100°, the water vapor will condense into water. If the condensed water droplets are small and suspended in the air, the water vapor will appear as white gas. But when the temperature is low, the white smoke coming out of the exhaust pipe is water vapor; if the condensed water droplets accumulate, they will become water. The water droplets discharged from the exhaust pipe are the result of water vapor generated after burning gasoline, which condenses in the exhaust pipe and muffler. However, when the ambient temperature is high, the water vapor is discharged before it condenses. When the ambient temperature is low, the water vapor condenses into water droplets on the exhaust pipe wall and flows out with the exhaust. This phenomenon is relatively normal in most cars.
If there are a lot of them, there may be water in the exhaust pipe. Therefore, it is recommended that you go to the store where you purchased it to get a replacement one. If there is a warranty, it will be free of charge.
Smoke exhaust
After the diesel engine is started, a large amount of gray-white smoke is emitted from the exhaust pipe
Failure analysis:
This kind of failure is generally caused by the diesel fuel injected into the cylinder being discharged without ignition and combustion or the cooling water entering the combustion chamber.
Cause of failure:
The fuel injector of 1 individual cylinder has poor fuel atomization.
2The injection pressure is low.
3. There is serious oil dripping from the fuel injection nozzle.
4. The ambient temperature is too low, resulting in no combustion or poor combustion in individual cylinders.
5 There is water in diesel fuel.
Water droplets seeped into 6 individual tanks.
7. The fuel supply advance angle is incorrect.
Troubleshooting methods:
For this kind of fault, the cylinder cutoff method should be used to judge, and the oil cutoff inspection should be carried out cylinder by cylinder to find out the abnormal cylinders and damaged parts.
1 First, start the diesel engine until the speed reaches about 700r/min, and then perform oil cutoff inspection cylinder by cylinder. When the high-pressure oil pipe of the second cylinder was disconnected, it was observed that the exhaust smoke changed from the original gray-white smoke to a large amount of white smoke, which indicated that there was an internal fault in the second cylinder.
2. Disassemble the fuel injector of the second cylinder, and then check the fuel injection pressure and fuel atomization quality. It is found that the fuel injector spare parts are leaking oil. After replacing the spare parts, start the diesel engine again after assembly and observe the smoke exhaust situation. It is found that the exhaust smoke has changed from the original gray smoke to a large amount of white smoke, indicating that water has entered the combustion chamber. The cylinder head, cylinder gasket, and cylinder liner should be disassembled and inspected.
3. After shutdown, when disassembling the cylinder head, it was found that the cylinder head nuts of the first and second cylinders had 4 nuts that were tightened with a torque of 100N·m, and the cylinder head nuts became loose. This situation is caused by the tightness of the cylinder gasket, causing water to enter the combustion chamber.
4. After re-tightening as required with a torque of 280N·m, after starting the diesel engine for 5 minutes, the white smoke from the exhaust pipe disappears, and the fault is eliminated.
Diagnostic treatment
When the engine is started, a large amount of white smoke is emitted from the exhaust pipe, which is generally not a fuel supply system failure.
⑴_Reason
① _There is water in diesel fuel. The water evaporates into steam in the cylinder and is discharged from the exhaust pipe.
② _The cylinder head bolts are loose or the cylinder gasket is damaged, allowing cooling water to enter the cylinder.
③ _There are trachoma or cracks somewhere in the cylinder block or cylinder head, and water enters the cylinder and evaporates out.
⑵_Diagnosis and treatment methods
① Approach the outlet of the exhaust pipe muffler with your hand. If there are water droplets on your hands when they are wet, it is confirmed that water has entered the cylinder.
② Check whether there is water in the diesel fuel. Check whether there is a large amount of water in the oil-water separator. If there is a large amount of water, the fuel quality is poor. First, the water in the high and low pressure oil lines should be removed; then open the drain plug of the fuel tank to drain out the water in the fuel tank, and finally flush the fuel tank with clean diesel.
③Open the water tank cover, press the starter button and observe whether there are bubbles in the water surface of the water inlet.
If there is water in the engine oil, or there are bubbles emerging from the water surface of the water inlet, it means that the cooling water has entered the cylinder.
④ Before disassembling the cylinder head, check the tightness of each bolt. If there are loose bolts, tighten them and then check for leaks. If there is still water leakage, proceed to the next step of inspection.
⑤ To further find the specific leakage location, inflate the water tank to a pressure of no more than 200kPa, open the oil pan, and check the leakage location at the bottom of the engine; then open the cylinder head, look at the bottom of the cylinder head and cylinder gasket, and check the fault location. For parts leaking into the cylinder, repair them with replacement parts or replace them with new assemblies.
Fault diagnosis
Determine the fault of diesel engine exhaust smoke: The diesel engine exhaust pipe should normally discharge colorless gas. If the exhaust pipe emits black smoke, white smoke or blue smoke, it means that the engine is faulty. The exhaust gas emissions not only affect the surrounding environment, but are also a warning to the user, and the engine fault must be eliminated in time.
1. Black smoke coming from the trachea
Analyze the cause of the failure:
(1) The air filter is seriously clogged.
(2) The fuel injection time is too late.
(3) The fuel injector is faulty or the newly installed fuel injector is of the wrong model.
(4) The fuel injection pump is faulty or the smoke limiter (or boost compensator) is improperly adjusted.
(5) Supercharger failure.
(6) Intercooler failure.
(7) The exhaust brake valve is in the closed position.
(8) The cylinder pressure is insufficient.
Judgment and troubleshooting methods:
According to the above reasons, they are discussed as follows:
(1) Before checking the exhaust pipe for black smoke, the air filter should be removed first. If the black smoke from the diesel engine disappears, it means that the air filter is severely clogged and the air intake is insufficient, causing black smoke. At the same time, you should also check whether the air intake pipe is blocked, such as the air intake hose is flattened, etc.
(2) Too much fuel supply from the fuel injection pump or too uneven fuel supply to each cylinder will cause black smoke to emit from the exhaust pipe. Therefore, the fuel supply volume of the fuel injection pump must be readjusted. Improper adjustment of the smoke limiter will also cause black smoke to emit from the exhaust pipe. Adjusting the smoke limiter adjustment screw outward can reduce the amount of smoke exhaust, but adjusting it too much will cause the engine to become weak.
(3) Severe wear of the compressor impeller or turbine of the supercharger will reduce the air intake volume, causing black smoke to emit from the exhaust pipe. Serious air leakage from the exhaust pipe gasket or supercharger interface gasket will also cause insufficient air intake, black smoke from the exhaust pipe, or reduced engine power.
(4) Poor heat dissipation of the air-to-air-cooled intercooler will reduce the air intake and cause black smoke to emit from the exhaust pipe. Therefore, the intercooler should be cleaned frequently during daily maintenance to make it smooth.
(5) If the exhaust brake valve is closed, it will cause a lot of black smoke to emit from the exhaust pipe, and the engine will not accelerate well and is weak.
(6) Insufficient cylinder compression pressure is one of the main reasons for black smoke from the exhaust pipe.
If the cylinder pressure is insufficient, after the engine is started, gray-white smoke will initially emit, which will turn into black smoke as the temperature of the diesel engine increases.
Xinghuo diesel generator maintenance manufacturer analyzes the main reasons for insufficient cylinder pressure:
(1) The valve clearance is too large or there is no clearance;
(2) The valve seat ring is not tightly sealed;
(3) The matching gap between the piston and the cylinder is too large; the piston ring loses elasticity or breaks and leaks too much;
(4) The camshaft is severely worn, causing insufficient air intake and poor exhaust. Check the wear of the camshaft. Use a 10mm dial indicator to measure the valve lift. If the wear is serious, it must be replaced.
2. White smoke coming from the exhaust pipe
Analyze the cause of the failure:
(1) There is water in the oil, or water enters the cylinder due to a damaged cylinder gasket, cracked cylinder liner or cylinder head leaking, etc.
(2) The camshaft of the fuel injection pump of some cylinders is severely worn, causing the injection time of the cylinder to lag too much. The diesel cannot be completely burned in the cylinder, which will also cause white smoke to emit from the exhaust pipe.
(3) The atomization of the fuel injector is poor or there is more than one washer installed under the fuel injector. Therefore, when replacing the fuel injector, the copper pad inside should be taken out.
(4) The water-cooled intercooler leaks, and cooling water enters the cylinder from the intake pipe.
(5) The sealing ring at the turbine end of the supercharger is not tightly sealed, and the oil is directly discharged from the exhaust pipe, forming "white smoke" in the exhaust pipe. If the exhaust pipe emits serious white smoke, be sure to carefully check whether the supercharger is leaking oil while checking that other parts are normal.
(6) The temperature is too low and the cylinder temperature is difficult to rise. Especially in the morning, white smoke is emitted when the engine is first started. It turns into blue smoke after the car is warmed up, and soon becomes colorless. This is a normal phenomenon and should be distinguished from a malfunction.
(7) When the vehicle is driving, if the engine suddenly becomes weak and a lot of white smoke comes out of the exhaust pipe, it is usually caused by too late fuel supply.
The main reasons analyzed are: the connecting screw on the fuel injection pump coupling is loose or the steel piece is broken; the air compressor shaft is broken; the fuel injection pump shaft is broken.
3. Blue smoke coming from the exhaust pipe
Formation of blue smoke: engine oil enters the combustion chamber and is burned and then discharged from the exhaust pipe.
Analyze the cause of the failure:
(1) The intake valve oil seal is not tightly sealed, and the oil enters the combustion chamber and burns.
(2) The piston ring loses elasticity or breaks; the cylinder liner is severely worn, and the engine oil escapes into the combustion chamber. In this case, there will generally be a large amount of exhaust gas coming out of the exhaust pipe.
(3) The sealing ring at the impeller end of the supercharger compressor is not tightly sealed, and the oil enters the cylinder combustion chamber for combustion.

