Before anything is ordered, clean the old pipe and read the number stamped into the bracket or rolled onto the tube. Compare it character by character with the figures on this Volvo Turbo Oil Pipe 22562951, since FM and FH build years differ in bracket detail while the casting number stays close. Photograph the stamping, note the engine variant from the plate, and match both against the parts list rather than the model name.
These return lines fail at the turbo end first, where the flange sees the highest temperature and the least support, and the weld toe begins to weep before it splits. A second common loss is fatigue at the bracket weld, driven by engine movement over rough ground. The third is corrosion working from the inside out, when acidic oil sits in a low bend through long idle periods.
The 22562951 assembly is drawn from seamless tube, bent to the original routing and finished with machined flanges rather than pressed ones. Sealing faces are turned flat and parallel so the gasket loads evenly across its width, and the bore at each flange is deburred by hand. Bore size is held to the original through the whole run, so a tight radius cannot pinch the drain.
Fit the turbo end first and leave the fasteners finger tight, then bring the lower flange to the block and align the bracket before tightening anything fully. Check the old gasket face for pitting, confirm the bore is clear, and make sure the pipe does not rest against the manifold. Work from the upper joint down to the lower one, then refill and look for weeping after the first heat cycle.

Hot Tags: volvo turbo oil pipe 22562951, China volvo turbo oil pipe 22562951 manufacturers, suppliers, factory


